| |
|
NEWS
The
Cutting Edge of Technology
The 9R Razor is now available in our 50mil, .250" travel series probes.
This 9R Razor is designed to contact solder domes and test pads on 50mil centers.
PDF
New Tip style for Bead Probe Technology.
Our new micro-serrated tip styles offer an added solution in extreme
conditions where contaminants, fluxes or oxides make it difficult to achieve reliable contact.
PDF
New Long-Stroke Teradyne Interface Probes
This new probe can be used as replacements in Teradyne’s
TestStation LH and LX test systems. PDF
Our new integraMate ICS 40 Series high reliable hyperboloid contacts
are
designed to mate with Ø.40mm
pins & used on .050" centers.
PDF
|
|
| |
|
|
|
 |
| |
| |
|
| |
X75-40 Series ~ .075 (1.91) Centers, .400 (10.16) Stroke
| |
|
|
 |
| |
|
Termination Extraction Tools |
 |
|
Order the ET-X75A for removing a damaged termination from its mounting hole when the Probe and Optional Spacer Plates are removed. Order the ET-X75A-EXT for removing a damaged termination from its mounting hole when the Probe and optional Spacer Plates are installed.
|
| |
|
|
| |
|
Termination Insertion Tools |
 |
|
Order the IT-X75A-FLUSH or IT-X75A SET .XXX (.000/.140 [0.00/3.56]) tools to install X75-25/40 terminations.
|
| |
|
|
| |
|
Pin Gauge Tools |
 |
|
Mounting
holes in AT7000, G10/FR4
or similar materials for
the Probe Plate should be
gauged at .0545/.0555 [1.384/1.409]
diameter using PG-X75A-P pin
gauge. Mouning holes in
AT7000, G10/FR4 or similar
materials for the Back Plate
(wired) should be gauged
at .0515/.0525 [1.308/1.333]
diameter using PG-X75A-T pin
gauge. Mounting holes in
AT7000, G10/FR4 or similar
materials for the Back
Plate (wireless) should
be gauged at .038/.039 [0.965/0.990]
diameter using PG-X50T pin
gauge.
|
| |
|
|
| |
|
Probe Installation Tools |
 |
|
Use PT100/75 to install X75-25 or X75-40 probes.
|
| |
|
|
| |
|
X Probe Extraction Tool |
 |
|
Order the PEX75 for removing damaged X Probe tubes without damaging the fixture. |
| |
|
|
| |
|
Indicator Probes |
 |
|
Use IPX75-4010 or IPX75-4040 to measure probe stroke in a test fixture (plunger remains at deflected position). |
All specifications subject to change without notice. All dimensions are in inches [mm].
All spring forces in ounces [gms].
|
| |
|
|
|
